XD CARBINE CONVERSION UNIT – XD/MOD2/XD(M)

One of these is the starting point to design your customized XD Carbine Conversion Unit (CCU). Each base model (shown below) comes with a 6″ Standard Rail and Molded Fore Grip. If you have your own M4 stock, buffer tube, castle nut and lock ring, our M4 Adapter will accept both commercial and Mil-Spec tubes. Every unit is test fired before it ships. Other rail choices are available which may replace the Standard Rail/Molded Fore Grip. All of our rails are Picatinny. Choose from our ACCESSORIES page to customize your CCU.

WHICH PISTOL MODELS FIT THE CCU:

Yes, these models work:

XD:
4″ & 5″ 9mm/40SW/45ACP – YES

XD Mod 2:
4″ – 9mm/40SW/45ACP – YES
5″ – 9mm/40SW/45ACP – YES

XD(M):
3.8″ Compact & 3.8″ 9mm/40SW – YES
4.5″ 9mm/40SW/45ACP – YES (includes threaded barrel models)
5.25″ 9mm/40SW/45ACP – YES

No, these models DO NOT work:

XD:
3″ Sub Compact – NO
Any Thumb Safety Model – NO
HS2000 – NO

XD Mod 2:
3″ & 3.3″ – NO

XD(M):
3.8″ Compact 45ACP – NO

XDS:
All models – NO

XDE:
All models – NO

To ask questions, or if you are ready to place an order, please call us at 866-433-2122

PROUDLY MADE IN THE USA flag

INSTALL IS QUICK AND EASY!

The “Feed Ramp”

This is a feed ramp and it is used with all XD frames. This device is necessary for proper feeding with these frames. One feed ramp is included with each CCU for XD pistols. Once the CCU has been properly assembled, the feed ramp cannot fall out. A small magnet retains this part in the frame during assembly/disassembly.

FOR NEW ORDERS ONLY – Accessory rails are factory installed.

XD and XD(M) magazines are not interchangeable. Within the XD (Mod 2 uses XD mags) models the 9mm and 40SW are interchangeable, so for example if you have an XD 4″ Service 40SW but want to get the CCU in 9mm you can do that, just purchase 9mm XD magazines. The same is true for the XD(M) models. In both models the 9mm & 40SW magazines won’t work in 45ACP frames and vise versa.

CCU vs Pistol Slide: The CCU does NOT lock open after the last round is fired. The XD trigger and grip safeties still work with the CCU in place.

NOTE: Factory Loaded Ammunition Only. Mech Tech recommends only using good quality factory loaded ammunition in the CCU which meets SAAMI, CIP or NATO standards. The CCU is a blowback operated action and is capable of safely firing ammunition up to +P. DO NOT USE +P+ or ‘hotter’ loads.

NOTE: “XD, XDM & Springfield” are a registered trade names and Mech Tech Systems Inc. is not affiliated with Springfield. Springfield has not endorsed the CCU and the fact that Mech Tech Systems Inc. provides the CCU as a Springfield accessory is in no way intended to imply that Springfield sanctions or is in any way associated with the product.